Single colour Touch Series Remote
This brand new product enables you to control the brightness and intensity of our strip lights with the tip of your finger.
-No need for hard pushing or sticky buttons!
-Goes through walls
-Recent dimming memory feature
Features of the Single Color Dimmer Touch Remote
Control the dimming in multiple ways:
Use the dimming wheel to scroll through and stop at your preferred dimming level.
In the center of the wheel, there are two buttons. These are "Short cuts" to dim down to 10% or up to 100%.
The buttons on the bottom of the remote can be used to increase or decrease brightness levels by 10%.
Technical Parameters
Input voltage: DC 12-24V
Output channel: three signal output (6A/channel) = total 216W(12V) or 432W (24V).
There are three (-) terminals and one (+) terminal at 6 amps each. This is so you may run multiple runs in parallel.
Brightness steps: 256 Levels of brightness on the wheel
Brightness Levels: 10
Max remote distance: 75ft without barrierrs
Controller: RF RGB Touch Controller--Uses (3) AAA batteries
Radio Frequency: 433MHz
Working Temperature: -30C to +60C
Will the remote remember what dimming level I was on?
Yes. Whether you turn the strips off from the remote or through a wall switch, the controller will remember the exact dimming level you had the strips previously.
Can I have more than two remotes in one area?
Yes, you can. However we have seen rarly that there is some RF interference from the other remote. If this happends, you need to turn off one set of lights while changing others.
Do I need line of site to change colors of my LED strip lights from the remote and control box?
No, RF (Radio Frequency) does not require line of sight. You can use this through walls and over 75 feet with no obstacles.
There are four terminals! What are the extras for?
You can connect multiple runs of LED strip lights, or connect one high wattage strip to both terminals.
